Removing The Oven Control & Display Boards And The Touch Panel Assembly - KitchenAid KAC-24 Technical Education

REMOVING THE OVEN CONTROL & DISPLAY BOARDS
AND THE TOUCH PANEL ASSEMBLY
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so could result in death or
electrical shock.
CAUTION: When you work on the microwave
oven, be careful when handling the sheet metal
parts. Sharp edges may be present, and you
can cut yourself if you are not careful.
1. Disconnect the electrical power to the
microwave oven.
2. Pull the microwave oven assembly for-
ward several inches so that you can ac-
cess the sides of the front panel (see page
2-2 for the side trim and mounting screw
removal procedure).
3. Remove the screws from the oven control
panel.
Oven Control Panel Screw
(1 On Each Side)
4. To remove the oven control panel, pull it
out at the bottom, and lift and unhook it
from the oven cabinet support at the top.
Oven
Control
Panel
Lift Off
Top
Support
Pull Out
5. Pull the ground clip on the end of the green
wire from the edge of the metal panel, and
disconnect the wire connectors from the
board. Set the panel face down on a
padded surface to protect the finish.
Ground Clip
Continued on the next page.
2-3
Wire Connectors