Yamaha BT1100 2002 Service Manual page 288

SHAFT DRIVE
Bearing retainer wrench
90890-04050
3. Install:
• gear coupling
• self-locking nut
(with the special tool 1)
Coupling gear/middle shaft tool
90890-01229
4. Install:
• ring gear bearing housing
(along with the ring gear, but without the
thrust washer)
5. Adjust:
• ring gear backlash
Refer to "MEASURING THE RING GEAR
BACKLASH" and "ADJUSTING THE RING
GEAR BACKLASH".
6. Measure:
• ring-gear-to-thrust-washer clearance
a. Remove the ring gear bearing housing (along
with the ring gear).
b. Place four pieces of Plastigauge
original thrust washer and the ring gear.
c. Install the ring gear bearing housing and tight-
en the bolts, and nuts to specification.
Ring gear bearing housing bolt
23 Nm (2.3 m•kg)
Ring gear bearing housing nut
23 Nm (2.3 m•kg)
NOTE:
Do not turn the final drive pinion gear and ring
gear while measuring the ring-gear-to-thrust-
washer clearance with Plastigauge
6-83
CHAS
130 Nm (13.0 m•kg)
between the
®
® .