Indoor Unit Installation Drawings - Daikin FTXS50FV1B Installation Manual

Indoor Unit Installation Drawings

Screws
(Field supply: M4 × 25L)
Front panel
50mm or more
from walls
(on both sides)
Air filters
B Titanium Apatite Photocatalytic
Air-Purifying Filter
Tabs (upper 3 locations)
Tabs (lower 3 locations)
B
Insert the upper side of the Titanium Apatite
Photocatalytic Air-Purifying Filter into the tabs
(upper 3 locations), push the lower side of the filters
up a little and into the tabs (lower 3 locations).
Intelligent-eye sensor (FTXS, FTX, FTKS only)
CAUTION
1) Do not hit or violently push the Intelligent-eye sensor. This can lead to damage and malfunction.
2) Do not place large objects near the sensor. Also keep heating units or humidifiers outside the sensor's detection area.
■English
How to attach the indoor unit.
Hook the claws of the bottom frame
to the mounting plate.
If the claws are difficult to hook,
remove the front grille.
How to remove the indoor unit.
Push up the marked area (at the
lower part of the front grille) to
release the claws. If it is difficult to
release, remove the front grille.
30mm or more from ceiling
M4 × 16L
Service lid
Opening service lid
Service lid is opening/closing type.
Opening method
1) Remove the service lid screws.
2) Pull out the service lid diagonally
down in the direction of the arrow.
3) Pull down.
M4 × 16L
Front grille
A Mounting plate
The mounting plate
should be installed on a
wall which can support the
weight of the indoor unit.
Caulk
pipe hole
gap
with putty.
Intelligent-eye sensor
(FTXS, FTX, FTKS only)
D Wireless
remote
controller
Screws
(Field supply: M3 × 20L)
A Mounting
plate
Clip
Bottom frame
Mark (rear side)
Cut thermal insulation
pipe to an appropriate
length and wrap it with
tape, making sure that no
gap is left in the insulation
pipe's cut line.
Wrap the insulation pipe with
the finishing tape from bottom
to top.
Before screwing the remote
controller holder to the wall, make
sure that control signals are
properly received by indoor unit.
E
Remote
controller
holder
4