Indoor Unit Installation Drawings - Daikin FTXS25G2V1B Installation Manual

Indoor Unit Installation Drawings

A Mounting plate
Screws
(Field supply: M4 × 25L)
Front panel
50mm or more from walls
(on both sides)
Air filters
Titanium Apatite Photocatalytic
B
Air-Purifying Filter (2)
Titanium Apatite
Photocatalytic
Air-Purifying Filter
Filter frame
Tab
Intelligent-eye sensor
CAUTION
1) Do not hit or violently push the Intelligent-eye sensor. This can lead to damage and malfunction.
2) Do not place large objects near the sensor. Also keep heating units or humidifiers outside the sensor's detection area.
■English
The mounting plate
should be installed on a
wall which can support the
weight of the indoor unit.
M4 × 16L
Opening service lid
Service lid is opening/closing type.
Opening method
1) Remove the service lid screws.
2) Pull out the service lid diagonally
down in the direction of the arrow.
3) Pull down.
Air filter
How to attach the indoor unit.
Hook the claws of the bottom frame
to the mounting plate.
If the claws are difficult to hook,
remove the front grille.
How to remove the indoor unit.
Push up the marked area (at the
lower part of the front grille) to
release the claws. If it is difficult to
Front grille
release, remove the front grille.
30mm or more
from ceiling
Caulk
pipe hole
gap
with putty.
Intelligent-eye sensor
Service lid
D
Wireless
remote
controller
Screws
(Field supply: M3 × 20L)
A Mounting
plate
Clip
Bottom frame
Mark (rear side)
Cut thermal insulation
pipe to an appropriate
length and wrap it with
tape, making sure that no
gap is left in the insulation
pipe's cut line.
Wrap the insulation pipe with
the finishing tape from bottom
to top.
Before screwing the remote
controller holder to the wall,
make sure that control
signals are properly
received by indoor unit.
E
Remote
controller holder
6