Engineering Mode - Vision Fitness R2200HRT Owner's Manual

ENGINEERING MODE

Engineering mode consists of 13 optional settings. Use the engineering
mode to enable certain features or displays on your Bike console.
ENTERING AND USING ENGINEERING MODE
• Press and hold the UP ▲ and DOWN ▼ buttons for approximately three
seconds.
• The console will beep and display engineering modes and optional
settings. Use the UP ▲ or DOWN ▼ buttons to scroll through the options.
Press the ENTER button to select the appropriate mode or setting.
OPTIONAL SETTINGS
S E T T I N G
HARDWARE TEST
ACCUMULATED DISTANCE
ACCUMULATED TIME
DOT DISPLAY MODE
HRT TYPE MODE
MACHINE MODE
SPEED MODE
BEEPER MODE
DEFAULT WEIGHT SET
DEFAULT AGE SET
DEFAULT LEVEL SET
DEFAULT TIME SET
LED TEST
• Use the UP ▲ and DOWN ▼ buttons within each setting to change the setting.
• Press the ENTER button to save settings.
• To EXIT engineering mode, press and hold the START button for three seconds.
D E S C R I P T I O N
TEST USED BY SERVICE TECHNICIANS TO TEST EDDIE CURRENT BRAKE SYSTEM.
MEASURES TOTAL DISTANCE IN MILES ON YOUR BIKE.
MEASURES TOTAL TIME IN HOURS ON YOUR BIKE.
CONSOLE DISPLAY AVAILABLE WHEN YOUR BIKE IS NOT IN USE. TURN ON OR OFF.
USED BY SERVICE TECHNICIANS TO ASSURE PROGRAMMING FOR YOUR BIKE IS CORRECT.
USED BY SERVICE TECHNICIANS TO CHECK IF THE CONSOLE IS SET TO BIKE MODE OR
ELLIPTICAL MODE.
ALLOWS YOU TO SET EXERCISE FEEDBACK TO ENGLISH (MILES) OR METRIC
(KILOMETERS) SYSTEM.
ALLOWS YOU TO TURN THE BEEPER ON OR OFF.
ALLOWS YOU TO SET THE WEIGHT THAT THE COMPUTER WILL DEFAULT TO DURING SETUP.
ALLOWS YOU TO SET THE AGE THAT THE COMPUTER WILL DEFAULT TO DURING SETUP.
ALLOWS YOU TO SET THE LEVEL THAT THE COMPUTER WILL DEFAULT TO FOR ALL
PROGRAMS.
ALLOWS YOU TO SET THE TIME THAT THE COMPUTER WILL DEFAULT TO FOR ALL
PROGRAMS.
TEST USED BY SERVICE TECHNICIANS TO TEST LED DISPLAYS.
35