Engineering Mode - Vision Fitness SIMPLE Owner's Manual

ENGINEERING MODE

Engineering mode consists of six optional settings. Use the engineering mode
to access information and enable certain features or displays on your console.
ENTERING AND USING ENGINEERING MODE
• Press and hold the UP s and DOWN t keys for approximately three
seconds.
• The console will beep and display engineering modes and optional
settings. Use the UP s or DOWN t keys to scroll through the options.
Press the ENTER key to select the appropriate mode or setting.
OPTIONAL SETTINGS
S E T T I N G
ENG1 – LCD TEST
ENG2 – HARDWARE TEST
ENG2 – ACCUMULATED TIME/
ACCUMULATED DISTANCE
ENG3 – MACHINE AND
UNITS MODE
ENG4 – DEFAULT TIME SET
ENG5 – DEFAULT LEVEL SET
ENG6 – PRODUCT SELECTION
AND MODEL CONFIGURATION
• Use the UP s and DOWN t keys within each setting to change the setting.
• Press the ENTER key until you hear 3 beeps to save settings.
• To EXIT engineering mode, press and hold the START key for three seconds.
28
D E S C R I P T I O N
TEST USED BY SERVICE TECHNICIANS TO TEST LCD DISPLAYS
TEST USED BY SERVICE TECHNICIANS TO TEST EDDIE CURRENT BRAKE SYSTEM
MEASURES TOTAL TIME USED IN HOURS AND MEASURES TOTAL DISTANCE USED IN
MILES
USED BY SERVICE TECHNICIANS TO CHECK IF THE CONSOLE IS SET TO BIKE MODE OR
ELLIPTICAL MODE, SHOWS YOU IF THE EXERCISE FEEDBACK IS SET TO THE ENGLISH
(MILES) OR METRIC (KILOMETERS) SYSTEM AND DISPLAYS THE SOFTWARE VERSION
ALLOWS YOU TO SET THE TIME THAT THE COMPUTER WILL DEFAULT TO FOR ALL
PROGRAMS
ALLOWS YOU TO SET THE LEVEL THAT THE COMPUTER WILL DEFAULT TO FOR ALL
PROGRAMS
ALLOWS YOU TO CONFIGURE YOUR CONSOLE TO THE PROPER PRODUCT (BIKE OR
ELLIPTICAL) AND MODEL NUMBER IF IT WAS NOT DONE CORRECTLY IN THE INITIAL SET UP