Operations - Windsor Clipper CLP12 Operating Instructions Manual

SOLUTION
BRUSH
INT
ON
CONT
1/8in
(3mm)
CORRECT
INCORRECT
VACUUM
ON
CLIPPER 98630 12/14/98
STEP
Remove electrical cord and literature
1
from recovery tank. Fill solution tank
(see filling instructions page 7).
STEP
Plug cord into grounded outlet. Note:
2
Be sure dome is seated on recovery
tank, and float shut-off is installed
correctly.
STEP
Adjust brush to proper setting. Note:
3
For good operation the brush must
skim the carpet. If circuit breaker
trips raise brush to prevent damage
to motor or carpet.
STEP
Turn on brush and vacuum motor
4
switches ("ON"="I"). Turn on solution
switch for continuous spray or set
switch to intermittent to allow use of
trigger switches.

OPERATIONS

8