Friendly Robotics Robomow RL350 Operating & Safety Manual page 43

Message Displayed
Front/Rear bumper
pressed
CAUTION – DO
NOT attempt to
disable this safety
device in the event
you are unable to
isolate and correct
the problem. Contact
your service provider
for repair before
using.
Front Wheel
Problem
CAUTION – DO
NOT attempt to
disable this safety
device in the event
you are unable to
isolate and correct
the problem. Contact
your service provider
for repair before
using.
High temp.
Disc. charger
Keep charging if not
used
Keys locked
Low temp.
Disc. charger
Move from Wire
Mowing Overload
Cooling, Wait
No Wire Signal
Rain
GO for override
Ready
Keep Charging
Probable Cause/Event
- Front or Rear Bumper is constantly being pressed
- The Front Wheel has left the ground for more than
8 – 10 seconds.
- Robomow is charged through the plug and
ambience temperature is out of range (above
158ºF / 70ºC)
- Message is displayed every time the charger plug
is disconnected from the mower.
- Displayed when the mower isn't in operation and
not connected to the charger/Docking Station for a
long time.
- Child lock feature has been activated
- Robomow is charged through the plug and
ambience temperature is out of range (below 32 ºF
/ 0 ºC); disconnect the charger plug from the
Robomower.
- The Robomow is positioned too close or on top of
the perimeter wire
- The mowing motors have been working under a
severe load for too long of a time.
- Perimeter Switch is not turned on or not connected
to the zone intended to mow
- Robomow detects rain upon GO pressing
- The battery is fully charged
Corrective/User Action
- Move mower away from object pressing
against bumper.
CAUTION – Remove power pack before lifting
the mower
- The Robomow has driven onto an obstacle,
raising the front end. Remove or exclude this
object from the mowing area.
- The Robomow is being used on a slope too
steep for safe mowing. Exclude this from the
mowing area.
- High grass is preventing the front wheel from
fully riding on the ground. Raise the cutting
height.
- The ground contains large holes or indentions
where the front wheel can drop into when
passing across. Fill these areas with dirt and
level off.
- Robomow charging is not allowed when the
ambience temperature is raised above 158ºF /
70ºC; Disconnect the charger plug and wait
until the temperature will go down or take the
Robomow to be charged in a cooler place.
- Press any key to change the display back.
- Send the mower back to the Docking Station
for charging / connect the charging plug or
continue in operation
- Press the Up ⇑ arrow key and then press the
'C' button. Child lock can be deactivated under
User preferences.
- Robomow charging is not allowed when the
ambience temperature is going down below
32ºF / 0ºC; Disconnect the charger plug and
wait until the temperature will go down or take
the Robomow to be charged in a warmer
place.
- Move the Robomow approximately 6 – 10 feet
(1.5 – 3m) away from the perimeter wire and
start again.
- Wait until the message 'Mowing Overload –
Press GO' is displayed.
- Make sure the Perimeter Switch is connected
to the correct zone and is turned on
- Do not operate Robomow in rainy weather and
wet grass; If you chose to override press the
GO button; The overriding is valid for the
current operation only
- Keep the charger (power supply) connected
and operating
43