Friendly Robotics Robomow RL350 Operating & Safety Manual page 39

Figure 5.4
5.2.5 Wide Scan
Wide scan provides the Robomow a secondary navigation technique, which can prove to be
beneficial in some lawns. Wide scan will increase the distance between subsequent legs of mowing
after each movement off of the perimeter wire. If it appears that the Robomow is simply driving along
the same path back and forth, activate wide scan.
5.2.6 Learn Edge
The default distance for edge mowing is approximately 1.5 to 2 rounds around the perimeter. This
feature allows the user to learn a specific distance in each operating zone in order to cause the
mower to cut the edge a specific distance, such as one full round. It will remain as a learned distance
until the edge is re-learned or the factory default edge is selected. It should be done when the Manual
Controller is in the holder and flush with the mower top. 'Learn Edge' gives you the ability to have the
Robomow learn the distance around the edge. Figure 5.5.
•
Position the Robomow to start edge mowing and place the Manual Controller in its holder
•
Follow the steps described in Figure 6.5 to begin the process
•
'Learn Edge' is specific to each zone, so be sure you have selected the correct zone where
you want the edge learned
Zone A Zone A MAX MAX
Press GO Press GO
Zone A Zone A 2:00 2:00
Press GO Press GO
Zone B: MAX
Press GO
User options
Press GO
User Preferences
Press GO
Learn edge
Press GO
Learn Zone B
Press GO to Learn
Learning Edge
Press GO to Learn
Learning Edge
STOP to Set
Figure 5.5
Scroll to select
different zones.
Scroll to select different operating
times. Times range from: 20
minutes to 2 hours to '
Use the 'Up' ⇑ or 'Down' ⇓ arrow keys
to scroll to the 'User Options' display.
GO'
Press '
GO' and scroll to
Press '
'Learn edge' option
GO'
Press '
Scrolling up or down will change the
zone, if a time is set for that zone.
GO'
Press '
Driving around perimeter. Follow the
mower and press the 'Stop' button when
the desired distance has been reached.
MAX'
39