Friendly Robotics Robomow RL350 Operating & Safety Manual page 20

ends to the connector (either wire to either screw, as there is no polarity) and tighten the screws as
shown in figure 1.10.
Strip back ¼ inch (6 mm) of
insulation from each wire end
and insert each perimeter wire
end into hole of connector.
Figure 1.10 – Inserting and Fastening Perimeter Wire to Connector
Take the Perimeter Switch and squeeze the tabs on both sides of the Perimeter Switch as shown in
figure 1.11, and remove the back cover from the Perimeter Switch.
Insert the 3 C-cell batteries in the battery holder as shown in Figure 1.12 and reassemble the Perimeter
Switch.
Figure 1.11 -
Squeeze to remove cover
1.10 Test the Perimeter Switch
Plug the perimeter wire connector into the Perimeter Switch (see figure 1.13) and press the ON button.
A small flashing green light next to the 'ON' button indicates the system is on and functioning correctly.
The Perimeter Switch also has an indicator for low batteries and for a disconnected/broken perimeter
wire. Figure 1.14.
Figure 1.13 –
Plug the plot connector into
the Perimeter Switch
20
screwdriver, tighten these
two screws to secure the
Figure 1.14 –
Perimeter Switch Operating Panel
Using a small flat blade
perimeter wires into the
connector
Figure 1.12 –
Inserting Batteries
ON button and
indicator light
Low battery
indicator light
Disconnected/broken
wire indicator light