Runco Signature Cinema SC-50d Series Installation & Operation Manual page 84

Operation
Copy/Paste
Copy Settings
Paste Settings
Copied From:
Input Source
Signal Format
Memory Preset
Downloaded From projector-manual.com Runco Manuals
• RVR: Use the RVR control to increase or decrease the Reflectance Volume Regulation
setting. RVR lets you adjust the aperture or iris size (the physical opening through the
lens; similar to an "f-stop" on a camera). Doing so allows you to optimize brightness
and contrast according to the amount of ambient light in the viewing area.
Use a lower setting (larger aperture = higher brightness) for rooms with a lot of ambient
light. Use a higher setting (smaller aperture = higher contrast) for more "theater-like"
viewing conditions (little or no ambient light).
Note
Input Image: The Input Image controls are functionally similar to those in the Picture
menu (refer to page 56), but are accessible only by entering the Calibration menu
passcode.
Note
Input Color: The Input Color controls are similar to those in the Display Color menu (see
above), but adjust the color balance of the incoming signal. These settings are also saved
independently for each input and display mode.
• Gain/Offset (HD1, HD2 and Component/SCART inputs only): These controls
operate similarly to those in the Display Color menu (described on page 65), but affect
the Y, Pb and Pr signal components rather than the red, green and blue channels.
• Chroma Delay: use the Chroma Delay control to correct a mis-aligned image from a
composite video source. Chroma delay in an image causes color shifts to occur to the
left of the vertical edge transitions, producing artificial shadows or a "halo" effect. If
necessary, adjust this setting to eliminate them.
• Noise Filter: To apply noise filtering to the input signal, select Noise Filter from the
Input Color menu. The Noise Filter is useful for clearing up noisy images from 480i
video sources.
Use the left- or right-arrow buttons to select the desired amount of noise reduction,
keeping in mind that higher settings (which reduce high frequencies) may also "soften"
the image.
Save ISF Night/Save ISF Day: Whenever you make a change to the ISF settings, you
should always save it. Select Save ISF Night or Save ISF Day from the Calibration menu to
do this.
Copy/Paste: You can copy and paste settings from one memory location to another.
This gives you a convenient starting point for creating a new preset based on an existing
one, to make the calibration process less time-consuming.
For example, you can use the Copy/Paste feature to:
• Apply settings from HDMI 1 to HDMI 2, or from HD1 to HD2.
• Calibrate an input for 720p source signals, then use those settings for 1080i sources.
HDMI 1
• Duplicate ISF Night settings for a given source and signal format and save them in the
1080p/60
Custom 1 memory preset.
ISF Night
RVR can only be used with the "Power" Lamp Mode setting (refer
to Lamp on page 66).
The Input Image settings establish the "zero point" for the Picture
menu settings, whose values represent offsets from the Input
Image settings. For example, if you set Brightness to 10 in this
menu, setting Brightness to 10 in the Picture menu results in an
actual setting value of 20 (10+10).
68 Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual