Memory Presets - Runco Signature Cinema SC-50d Series Installation & Operation Manual

Operation

Memory Presets

Memory Presets
ISF Night
ISF Day
Custom 1 Save
Custom 2 Save
Downloaded From projector-manual.com Runco Manuals
Phase (RGB, Component or SCART sources): This control adjusts the phase of the
pixel sampling clock relative to the incoming signal. Adjust the phase when an RGB,
Component or SCART image still shows shimmer or "noise" after Tracking has been
optimized.
Tip
For best results, use a good test pattern such as a smooth gray consisting of a clear
pattern of black and white pixels, or a similar "half on, half off" graphic image. Adjust the
slidebar until the image stabilizes and each pixel is clearly defined. You may notice that
you can stabilize the image at more than one point. Use either setting in such cases.
Tracking (RGB, Component or SCART sources): Tracking determines the frequency
of the pixel sampling clock, indicated by the number of incoming pixels per line, so that all
pixels generated by a particular source are sampled.
Steady flickering or several soft vertical stripes or bands across the entire image indicates
poor pixel tracking. Proper pixel tracking helps ensure that the image quality is consistent
across the screen, that aspect ratio is maintained and that pixel phase (see above) can be
optimized.
For each input, the DHD Controller lets you save image quality settings as presets that you
can recall at a later time. You can create up to four presets per input and display mode
(resolution and frame rate).
The DHD Controller stores the following display modes in each memory preset:
• 480i
Reset
• 480p
Reset
• 576i
• 576p
• 720p/24 Hz
• 720p/25 Hz
• 720p/30 Hz
• 720p/50 Hz
• 720p/60 Hz
• 1080i/50 Hz
• 1080i/50 Hz (Australia)
• 1080i/60 Hz
• 1080p/24 Hz
• 1080p/25 Hz
• 1080p/30 Hz
• 1080p/50 Hz
• 1080p/60 Hz
Use the Memory Presets menu to recall saved image presets, or to save image settings in
the "Custom 1" or "Custom 2" memory location. The currently-selected preset is indicated
by a " " to its left; in the example shown here, ISF Night is selected.
Adjust the Phase after adjusting Tracking (see below).
62 Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual