Advertisement
ANT500 Manual
6/10/99
For Installation of Combined Element and Amplifier/Tuner
The Antenna Element and Amplifier/Tuner can be used as a combined unit
for positioning on flat surfaces like the top of a TV cabinet. To avoid blocking
the broadcast signal, do not place the unit beneath the TV or any other
electronic component.
1.
2.
3. Connect one end of the second 6ft. Coaxial Cable to the "OUT (to
TV)" connector on the back of the Amplifier/Tuner Unit, and connect
the other end to the "Antenna" connector on the back of your TV or
VCR. Cables should be routed under the Antenna Element and out the
back to the "Antenna" of your video equipment.
4. The Amplifier/Tuner should be positioned in line-of-sight of the
Remote Control.
1. Connect the Power Adapter to the Amplifier/Tuner by inserting the plug
into the "DC Input" on the back of the unit.
2. Plug the Power Adapter into a 110/120 Volt, 60 Hz. Outlet.
3. Turn the Antenna ON by
pressing the POWER button on
the Amplifier/Tuner or by aiming
the remote at the Amplifier/Tuner
and pressing the POWER button.
A red indicator light on the
Amplifier/Tuner will show power
is ON.
6
1:07 PM
Page 6
Locate the Antenna Element. Connect the right
angle end of the Short Coaxial Cable to the
connector on the bottom of the Antenna Element.
Locate the Amplifier/Tuner. Attach the other end
of the cable to the "IN (Antenna)" on the back
of it. Place the combined Antenna Element and
Amplifier/Tuner in a spot visible to the remote
control (ideally on top of the TV).
Power
OUT
12vDC
(To TV)
500mA
IN
(Antenna)
Advertisement
