Table of Contents
Advertisement
Fit the tabs here in the case
of horizontal mounting.
Fit the tabs here in the
case of vertical mounting.
If you're performing printing with head cap used, this completes loading of the material.
If you're performing printing with no head cap used, then go on to the following steps.
The procedure from this point on is for when you're not using the head cap.
Knob
Stopper
Mount the center vise.
Fit the tabs on the bottom of the center vise
into the holes in the table on the unit.
If the material tilts, place a support in order
to keep the material horizontal.
Tabs
Press the Power/Movement button.
The head moves and stops at the location
where the tip of the nose cap touches the
surface of the material.
Loosen the knob.
Rotate the knob counterclockwise once.
Then you can move the stopper.
Chapter 3 Making Prints
3-2 Getting Ready
39
Advertisement
Table of Contents
