Table of Contents
Advertisement
When material is too large to be placed within the table
Adhesive
sheet
Material
Center Line
If you're performing printing with head cap used, this completes loading of the material.
If you're performing printing with no head cap used, then go on to the following steps.
The procedure from this point on is for when you're not using the head cap.
Knob
Stopper
Place the material in a way that the center
of the printing area comes to the center of
the scale on the table.
If the material tilts, place a support in order
to keep the material horizontal.
Center Line
Center of the
material
Press the Power/Movement button.
The head moves and stops at the position
where the tip of the head cap rides on the
surface of the material.
Loosen the knob.
Rotate the knob counterclockwise once.
Then you can move the stopper.
3-2 Getting Ready
Chapter 3 Making Prints
35
Advertisement
Table of Contents
