Table of Contents
Advertisement
3-2 Getting Ready
Conditions for Material When Printing Curved Surfaces *5
The table and figure below show the printing-assured area and the area reached by the marking pins with
respect to the diameter of the cylinder. Note, however, that the following conditions are assumed.
The head cap is used.
The material has circularity.
Diameter of cy-
lindrical material
10 mm (0.3 in.)
20 mm (0.7 in.)
30 mm (1.1 in.)
*5
For printing on curved surfaces, regardless of the shape or composition of the material, the image quality
of photographic data cannot be assured.
32
Chapter 3 Making Prints
Recommended printable area
(A)
2.0 mm (0.079 in.)
2.8 mm (0.11 in.)
3.4 mm (0.14 in.)
Area reached by the marking
pins (B)
2.8 mm (0.11in.)
4.0 mm (0.16 in.)
4.8 mm (0.19 in.)
Advertisement
Table of Contents
