IBM ThinkCentre 8141 User Manual page 34

4. Remove the metal shield from the drive bay by inserting a flat-blade
5. Make sure the drive that you are installing is set correctly as either a master or
6. Install a retainer bracket on the side of the drive.
7. Install the drive into the bay until it snaps into position.
18
User Guide
screwdriver into one of the slots and gently prying it loose.
a slave device.
Note: A serial ATA hard disk drive does not need to be set as either a master
or a slave device.
v If it is the first CD drive or DVD drive, set it as a master device.
v If it is an additional CD drive or DVD drive, set it as a slave device.
v If it is an additional parallel ATA hard disk drive, set it as a slave device.
Refer to the documentation that comes with your drive for master/slave
jumper information.
X * X X X X X X X * X
* X X X X X X X X * X