Assembly Instructions - Kärcher G 4000 RH Operator's Manual

Avoid tipping the machine on its
!
side.
SAVE THESE INSTRUCTIONS
WATER SUPPLY
(Cold Water Only)
CAUTION
When connecting the water inlet to
the water supply mains, local regula-
tions of your water company must be
observed. In some areas the unit
must not be connected directly to the
public drinking water supply. This is
to ensure that there is no feedback of
chemicals into the water supply. Di-
rect connection via a receiver tank or
backflow preventer, for example, is
permitted.
Dirt in the feed water will damage the
unit. To avoid this risk, we recom-
mend fitting a water filter.
STEP 1:
"
Prior to initial startup, cut off tip of oil
reservior cap on the pump.
STEP 2:
"
Prior to initial startup, put engine oil
(provided in bottle) in engine before
starting the engine.
For engine details see engine manual.

ASSEMBLY INSTRUCTIONS

Garden hose must be at least 5/8
!
inch in diameter.
Flow rate of water supply must not
!
fall below 4.0 GPM (gallons per
minute).
Flow rate can be determined by run-
!
ning the water for one minute into an
empty 5-gallon container.
The water supply temperature must
!
not exceed 104°F/40°C.
Never use the pressure washer to
!
draw in water contaminated with sol-
vents, e.g. paint thinners, gasoline,
oil, etc.
Always prevent debris from being
!
drawn into the unit by using a clean
water source.
Do not operate pressure washer
!
without the water turned on.
STEP 3:
"
Attach the handle to the frame of the
pressure washer. Align holes, insert
bolts, and tighten with knobs.
STEP 4:
"
Mount the gun/hose storage handle.
5
English