Figure 20. Positioning The Pinchwheels For 72-In (183-Cm) Paper; Insert The Dancer Bars - Ioline FlexJet User Manual

72 Inch Paper
Outer Pinchwheels

Figure 20. Positioning the pinchwheels for 72-in (183-cm) paper.

3. Make sure that the paper roll is centered on the feed shaft.
4. Move the pinchwheels into their proper positions over a tread and
under the white markers on the traverse rail. (See Figure 20.) Do
not place pinchwheels over drive shaft bearings.)
5. Lower the pinchwheels.

Insert the Dancer Bars

1. Lower the pinchwheels by pulling the lever toward the machine.
2. Hold the paper in place over the rear top bar and insert the rear
(heavy, gray) dancer bar into the rear dancer bar channel. Apply
gentle pressure to control the paper feed as gravity pulls the
heavy bar into the channel. See Figure 21.
3. Insert the front dancer bar into the front dancer bar channels.
Front Dancer Bar
(Silver light rod)
Figure 21. Inserting the dancer bars.
White Driveshaft Markers
Inner Pinchwheel Drive Shaft Bearings
Rear Dancer Bar
(Gray heavy rod)
Chapter 3: Operation
i
Note
Ensure that the paper roll is cen-
tered on the feed shaft.
33