Control Panel; Led Indicators - Schumacher SE-1-12S Owner's Manual

to the charger as shown using the nuts and bolts provided. Loosen
the battery retaining hardware enough that you can insert the bracket
between the bottom of the battery and the battery mounting tray as
shown. Position the charger so that it will not rub against the battery
or any other part of the vehicle, and then tighten the battery retaining
hardware. NOTE: Do not drill or puncture the battery.
Electrical Installation – The output leads of the charger are terminated
with 3/8" dia. ring lugs. Route and secure the AC cord and the output
wiring away from the gas line, carburetor or other hot, sharp, moving
or pinch parts to avoid damage to the insulation. Secure the AC cord
using a cable tie or equivalent. If you have difficulty connecting the
output leads, consult your local auto supply store, they may assist
you in finding a connecting device for your application.
10. ASSEMBLY iNSTRUCTiONS
Remove all cord wraps and uncoil the cables prior to using the battery
charger.
11.

CONTROL PANEL

LEd indicators

POWER ON (green) LEd: Indicates the charger is connected to an
AC power source and is receiving power.
CHARGEd (red) LEd: Indicates the battery is fully charged and the
charger is in maintain mode.
12. OPERATiNG iNSTRUCTiONS
accordance with the assembly instructions before it is used.
the 120V AC outlet, or it could result in damage to the charger.
Charging
1. Ensure that all of the charger components are in place and in
good working condition.
2. Connect the battery following the precautions listed in sections
6 and 7.
3. Connect the AC power following the precautions listed in section 8.
This battery charger must be properly assembled in
Do not start the vehicle with the charger connected to
• 9 •