Download Print this page

Schumacher 1010 Important Safety Instructions Manual

Schumacher battery charger owner's manual #2, cm-1, se-82-6, 83, 84, 86, 1010, 1010-2, 1015, mc-1, ws-63, 84, 86, 212, 1010, 1015, 1020. sec-1, 82-6, 84, 86, 1010, 1010-2, 1015, 1020.

Advertisement

Quick Links

280-600
801 BUSINESS CENTER DRIVE • MOUNT PROSPECT, ILLINOIS 60056-2179
Send Warranty Product Repairs to: 1025 E. Thompson Ave., Hoopeston, IL 60942-0280.
Call Customer Service if you have questions: 1-800-621-5485

IMPORTANT SAFETY INSTRUCTIONS

A.
SAVE THESE INSTRUCTIONS -
1.
safety and operating instructions for battery charger Models.
MODELS: #2, CM-1, SE-82-6, SE-83, SE-84, SE-86, SE-1010, SE-1010-2,
SE-1015, MC-1, WS-63, WS-84, WS-86, WS-212, WS-1010, WS-1015,
WS-1020.
Also models SEC-1, SE-82-6, SEC-84, SEC-86, SEC-1010, SEC-1010-2,
SEC-1015, SEC-1020.
A BATTERY CHARGER RECEIVES AC POWER FROM THE ELECTRIC OUTLET, AND
DELIVERS DC CURRENT TO THE BATTERY.
2. Before using battery charger, read all instructions and cautionary markings on (1)
battery charger, (2) battery and (3) product using battery.
3. CAUTION - To reduce risk of injury, charge only lead acid type rechargeable batteries.
Other types of batteries may burst causing personal injury and damage.
4. Use of an attachment not recommended or sold by the battery charger manufacturer
may result in a risk of fire, electric shock, or injury to persons.
5. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when
disconnecting charger.
6. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise
subjected to damage or stress.
7. An extension cord should not be used unless absolutely necessary. Use of improper
extension cord could result in a risk of fire and electric shock. If extension cord must
be used, make sure:
(a) That pins on plug of extension cord are the same number, size and shape as those
of plug on charger;
(b) That extension cord is properly wired and in good electrical condition; and
(c) That wire size is large enough for AC ampere rating of charger as specified below
AC INPUT RATING, AMPERES
Equal to or
Greater than
0
2
3
8. Do not operate charger with damaged cord or plug - replace them immediately.
9. Do not operate charger if It has received a sharp blow, been dropped, or otherwise
damaged in any way; take it to a qualified service man.
10. Do not disassemble charger; take it to a qualified serviceman when service or repair
is required. Incorrect reassembly may result in a risk of electric shock or tire.
11. To reduce risk of electric shock, unplug charger from outlet before attempting any
maintenance or cleaning. Turning off controls will not reduce this risk.
B.
WARNING - RISK OF EXPLOSIVE GASES
1. WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES
GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR THIS
REASON, IT IS OF UTMOST IMPORTANCE THAT EACH TIME BEFORE USING YOUR
CHARGER, YOU READ THIS MANUAL AND FOLLOW THE INSTRUCTION EXACTLY.
but less than
2
3
4
Page 1
ELECTRIC CORP.
This manual contains important
AWG SIZE OF CORD
Length of Cord, Feet
25
50
18
18
18
18
18
18
100
150
18
18
16
14
16
14

Advertisement

loading

Summary of Contents for Schumacher 1010

  • Page 1: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS - safety and operating instructions for battery charger Models. MODELS: #2, CM-1, SE-82-6, SE-83, SE-84, SE-86, SE-1010, SE-1010-2, SE-1015, MC-1, WS-63, WS-84, WS-86, WS-212, WS-1010, WS-1015, WS-1020. Also models SEC-1, SE-82-6, SEC-84, SEC-86, SEC-1010, SEC-1010-2, SEC-1015, SEC-1020.
  • Page 2: Personal Precautions

    Do not use battery charger for charging dry cell batteries that are commonly used with home appliances. These batteries may burst and cause injury to persons and damage to property.
  • Page 3 (as in mast vehicles), see #5. If positive post is grounded to the chassis, see #6. 5. For negative-grounded vehicle, connect POSITIVE (RED) clip from battery charger to POSITIVE (POS, P. + ) ungrounded post of battery. Connect NEGATIVE (BLACK) clip to vehicle chassis or engine block away from battery.
  • Page 4 Battery charger models having a voltage selector switch are for charging a 6 or a 12 Volt battery. Those having no voltage switch are intended for charging a 12 Volt battery only.
  • Page 5: Switch Setting

    Disconnecting from Battery: Before disconnecting from battery read instructions F. G and H carefully. N. STORAGE: Store battery charger In a dry area. O. PROBLEM CHECKLIST 1. If no meter reading, check the following: a. Remove the charger power cord plug from the AC outlet and recheck the battery charger clips for clean, tight connections.
  • Page 6: Limited Warranty

    OF THIS PRODUCT. THIS LIMITED WARRANTY IS NOT TRANSFERABLE. Schumacher Electric Corporation warrants this battery charger for two years from date of purchase at retail against defective material or workmanship. If such should occur. the unit will be repaired or replaced at the option of the manufacturer It is the obligation of the purchaser to forward the unit together with proof of purchase, transportation and/ or mailing charges prepaid to the manufacturer or its authorized representative.

This manual is also suitable for:

1010-210151020.1020. sec-121282-6 ... Show all