Answer Direct Connect Calls - Sonim XP STRIKE Get Started Manual

Make and Answer Direct Connect Calls

Answer Direct Connect Calls

When you receive a Direct Connect call, you hear
an incoming tone or the phone vibrates, depending
on your settings. You will see the Direct Connect
number or the caller's name (if available) on your
screen. You may also hear the caller's voice
through the loudspeaker. By default, the
loudspeaker is switched ON for direct calls. You
can turn the loudspeaker off and listen to Direct
Connect calls through the earpiece as you
would a regular call, or you can listen through
a headset.
1. Press Loudsp./Handset (right selection key) to
enable/disable the loudspeaker.
• If you enable the Direct Connect loudspeaker,
you will hear the caller's voice through the
loudspeaker on the back of the phone.
14
• If you disable the Direct Connect loudspeaker,
you will only hear the caller's voice through
the earpiece.
2. While the caller is speaking, their name or Direct
Connect number is displayed on the screen.
3. When the caller is finished speaking, their name
or Direct Connect number is no longer
displayed on the screen.
4. Press and hold the Direct Connect button and
wait for the tone and message ("Myself") to be
displayed on the screen. Begin speaking and
release the Direct Connect Button when you
are finished. Continue the Direct Connect call
as described previously.
Tip: Press to dismiss an incoming Direct
Connect call, or to end a current one.