Setting The Date Format; Setting The Date - Olivetti ECR 8200 S User Manual

3. Select System Initialization by pressing
4. The first field Language is highlighted. Check if the language indicated is the language you require for the cash
register. If it is, proceed to the next step, otherwise change the language by pressing
want is displayed, then press
5. Press to position on the next field,
be stored on the cash register , the maximum number of tables that can be tracked simultaneously and the type of
memory to use for storing Electronic Journal data, either the internal memory of the cash register or a removable
Storage Device (SD). If you are using an SD card, the number of lines that can be stored depends on its capacity. For
example, a 1GB card provides storage for 40 million transaction lines. Choose one of these combinations:
•
1500 PLU numbers & max 12000 lines stored internal memory, no table tracking.
•
2000 PLU numbers & max 11000 lines stored internal memory, no table tracking.
•
3000 PLU numbers & storage on memory card only, no table tracking.
•
500 PLU numbers & max. 12000 lines stored internal memory, max. 50 tables can be tracked.
•
1500 PLU numbers & max. 9000 lines stored internal memory, max. 70 tables can be tracked.
•
3000 PLU numbers, storage on SD only, max. 100 tables can be tracked.
Press until the combination you want is displayed, then press
If you choose to store the journal on the SD card, you must configure also the EJ System option
(see "Electronic Journal").
6. Press to position on the prompt:
The cash register is reset with the values you have programmed.
S D F
ETTING THE ATE ORMAT
1. Press to activate the menu system.
2. Select Programming Mode -> Configuration Setup -> Initial Setup -> Date FORMAT .
3. Press until the date format you require is displayed.
4. Press .
S D
ETTING THE ATE
1. Press to activate the menu system.
2. Select Programming Mode -> Configuration Setup -> Initial Setup -> Date setup .
3. Type the current date in the format you have selected.
4. Press .
NOTE: The date format can be changed at any time. Refer to the section "Setting the Date Format".
to position on System Initialization, then press
.
PLU/EJ/TABLE . Here you can set the maximum number of PLUs that can
Are you sure? Press until
until the language you
.
YES is displayed, then press
.
.
11