Precautions For Installation - Panasonic WV-CF374E Installation Manual

Precautions for installation

Panasonic assumes no responsibility for
injuries or property damage resulting from
failures arising out of improper installation
or operation inconsistent with this
documentation.
This product is designed to be used
indoors.
This product is not operable outdoors.
Do not expose the product to direct sunlight
for hours and do not install the product near a
heater or an air conditioner. Otherwise, it may
cause deformation, discoloration and
malfunction. Keep the product away from
water and moisture.
Installing place
Contact your dealer for assistance if you are
unsure of an appropriate place in your
particular environment.
• Make sure that the installation area is
strong enough to hold the product, such
as a concrete ceiling.
• Install the camera in the foundation area of
the architecture or where sufficient
strength is assured.
• If a ceiling board such as plaster board is
too weak to support the total weight, the
area shall be sufficiently reinforced.
Avoid installing this product in the follow-
ing locations.
• Location where it may get wet from rain or
water splash.
• Locations where a chemical agent is used
such as a swimming pool.
• Locations subject to steam and oil smoke
such as a kitchen.
• Locations near flammable gas or vapor.
• Locations where radiation or x-ray
emissions are produced.
• Locations where corrosive gas is
produced, Locations where it may be
damaged by briny air such as seashores.
10
• Locations where the temperature is not
within –10 °C to +50 °C.
• Locations subject to vibrations (This
product is not designed for on-vehicle
use.)
• Locations subject to condensation as the
result of severe changes in temperature (In
case of installing the product in such
locations, the dome cover may become
foggy or condensation may be caused on
the cover.)
Avoid moist or dusty places to install this
system.
Otherwise, lifetime of the internal parts may be
shortened.
Avoid installing this product in a place
with a high level of noise.
Installation near an air conditioner, an air
cleaner, a vending machine, or the like causes
noise.
Avoid installing and connecting during a
lightning storm. Otherwise, an electric
shock or fire may be caused.
Be sure to remove this product if it is not
in use.
Do not damage the power plug or cable.
Keep the camera cable away from the
lighting cable.
Failure to observe this may cause noise.
Radio interference
When the camera is used near TV/radio
antenna, strong electric field or magnetic field
(near a motor or a transformer), images may be
distorted and noise sound may be produced.
In such a case, run the camera cable through
specialized steel conduit tubes.