Table of Contents
Advertisement
Installation Instructions
Installation Precautions
Panasonic does not accept any responsibility for accident or damage during installation if procedure
in this manual is not followed.
To installation personnel
Read the "Installation Instructions" thoroughly and then perform the operation correctly and safely.
Also, always read the "Read this First!" (Page 6) of this manual as they contain important information.
After the installation, give the "Operating Instructions <Basics>" to the customer to save for future use.
Ensure that the installation work
complies with the technical standards
governing electrical equipment.
This unit is for indoor use only.
It cannot be used outdoors.
Avoid installation in a location where the
unit will be exposed to direct sunlight for
extended periods or near a cooling or
heating appliance.
Otherwise, deformation, discoloration,
malfunctioning and/or problems in operation
may result. Operate the unit where it will not
be splashed or sprayed by water.
Concerning the installation location
Install the unit in a stable location which will
not be susceptible to shaking. If the unit is
installed in a location which is susceptible to
shaking, this will cause the unit's images to
shake in turn.
Install the unit after conferring in detail with
your dealer.
Install the unit on a ceiling that is strong
enough (such as a concrete ceiling).
If the unit is to be installed on a ceiling which
is not strong enough, reinforce the ceiling
sufficiently first.
Use the unit with an installation where the
unit is suspended from an overhead
surface or with a stand-alone installation.
Do not use the unit on its side or tilted at an
angle.
[Note]
Be absolutely sure to use the 4 bracket
mounting screws (M4 x 10 mm) for mounting
the mount bracket. These are supplied with
the unit.
Do not use wood screws, nails, etc.
In the case of a concrete ceiling, secure the
unit using anchor bolts (for M4) or AY plug
bolts (for M4).
Recommended clamping torque M4 x 10
mm: 1.47 N · m {15 kgf · cm}
The withdrawal strength of the mounting
location for each screw must be at least
215.75 N {22 kgf}.
When mounting the unit on a ceiling made of
plasterboard, for instance, if it is not strong
enough to support its weight, either reinforce
the ceiling adequately or use the WV-Q105A
direct ceiling mount bracket, which is sold
separately.
When using a mount bracket which is sold
separately, read the handling instructions.
Do not hold the camera head while
undertaking the installation work. Doing so
may cause malfunctioning.
OK
Desktop Installation
9
OK
NG
Hanging Installation
NG
Advertisement
Table of Contents
