Superior MICAELA Installation, Use And Maintenance Instructions page 33

5 INSTALLATION OF THE CERAMIC PANELS
5.1 Stoves MANUELA, MIRIAM, STEFANIA, SILVIA
0) Unpack the monoblock and place it in the desired position near the entrance to the smoke stack, bearing in
mind the technical rules (smoke stack, pipes, chimney pot, air intake, etc.) listed in this booklet.
1) Level the monoblock and check that everything is in order inside the stove, making sure that all internal panels
are in the correct position and that there is nothing else inside the stove.
2) Remove the top cast iron plate, undoing the fixing screws.
3) Insert the ceramic side panels into position and secure them with the relevant brackets (diagram below);
compensating for any slack with the fibreglass tape provided.
SIDE PANEL
BASE
4) Insert the fascia into its correct position; compensate for any slack using the fibreglass tape provided.
5) Adjust the position of the shaped metal trims as required, loosening the fixing screws.
Replace the top plate and tighten up the fixing screws.
6)
HANDLE THE CERAMIC PANEL WITH CARE.
Fibreglass tape
as required
BRACKET
SIDE PANEL
SHAPED TRIM
33