Sony CCU-900 Installation And Maintenance Manual page 53

3-3-8. Settings for the Signals of the
Optional Boards
Setting the Three-time Speed Output Format
Either the MAV or the DISC2 format can be selected as
the video signal format of the three-time speed output
signal from the SS-A, SS-B and SS-C connectors on the
rear panel using the switch S1108 on the VPR-57 board.
The MAV format suits to the multi-access video disk
recorder MAV-555 (when the optional super motion input
board BKMA-520SS is installed). The DISC2 format
supports EVS-SLMS.
For more details, refer to Section 1-5. "Settings of Switch-
es and Controls on Boards."
Setting the Normal Speed Video Signal
Generation (Frame Interpolation)
When operating in the super motion mode, the CCU-900/
900P standard output mode (for SERIAL OUTPUT 1/2/3,
SERIAL MONITOR OUTPUT, PIX1/2 and WF1/2
connectors of the rear panel) enables the normal speed
video signal output to be executed with minimum unnatu-
ral movement from the three-time speed video signal.
How to set from CCU-900/900P
Perform setting using the switch S1109 on the VPR-57 board.
For more details, refer to Section 1-5. "Settings of Switch-
es and Controls on Boards."
CCU-900/900P IMM
How to set from MSU-700A/750
S1109
VPR
POWER ENABLE
REMOTE
1. Set 0 (REMOTE) to the switch S1109 on the VPR-57
board panel of the CCU-900/900P.
2. Press the MAINTENANCE button of the MODE
block of MSU-700A/750 to turn on the button.
The maintenance menu appears.
Maintenance Menu
Adjusting CAM SW Auto
Setup
Setting
Lens VCS
Adjusting Adjusting
SD Super
Adjusting Motion
3. Press [Super|Motion].
The super motion setting menu appears.
4. Select the desired mode of generating the normal
speed video signal using the Frame Interpolation
switches.
Off : Does not generate the normal speed video signal.
The same video signal as the output signal from
the SS-A connector on the rear panel is output as
the CCU standard output.
A : Standard interpolation ratio (Normally set)
B : Quick object mode
Used when the motion speed of object is high
and the video signal is unnatural with the setting
"A".
C : Slow object mode
Used when the motion speed of object is slow
and the video signal is unnatural with the setting
"A".
SuperMotion Setting
Field Rate
X1 X3
Frame Interpolation
Off A B
3-3. Video Signal System
LOCAL
VPR-57 board
Exit
Exit
C
3-13 (E)