Sony CCU-900 Installation And Maintenance Manual page 47

How to adjust using the MSU-700A/750
1. Press the MAINTENANCE button of the MODE
block of the MSU-700A/750 to light the button.
The maintenance menu will be displayed.
Maintenance Menu
Auto
Adjusting CAM SW
Setting Setup
Lens VCS
Adjusting Adjusting
SD Super
Adjusting Motion
2. Press [Adjusting].
The maintenance adjustment menu will be displayed.
Clear
VBS Camera
Phase
Level Output
Black White
Shading BlackSet
Shading
3. Press to display the maintenance adjustment
menu 2/2.
4. Press [CF|Shift] once.
The color frame output from the PIX1/2 and WF1/2
connectors on the rear panel of the unit is shifted by
one frame. Adjust the color frame until the color
frames of all the CCU outputs are synchronized.
Clear
Monitor
Output
CCU Monitor Output
CF
Shift
Skin Gate
CCU-900/900P IMM
Exit
Exit
SDI
Output
1
2
OHB
Matrix
Home
2
2
4 : 3 4 : 3
Maker Mod
Mode Level
3-3-4. Adjusting the Level of Signals for
Waveform Monitor
The video output signal of this unit can be checked on the
waveform monitor connected to the WF output connector.
Adjust the WF output signal level using the color-bar signal.
In the system with the MSU-700A/750, CNU-700/500 and
VCS-700, the video output signal can be checked on the
waveform monitor connected to the VCS-700. For more
details, refer to the system manual or the VCS-700 mainte-
nance manual.
Adjusting the WF Output Signal Level
Rotary encoder
MIC LEVEL
MENU
NORM NORM
OFF ON
POWER MIN MIN
CH-1 CH-2
1. While pressing the rotary encoder on the AT-122
board panel, set the MENU ON/OFF switch to ON.
The engineering menu will be displayed.
2. Press the BAR button of the MSU-700A/750, RCP-
740/741 or others and press the ENC button of the
WAVEFORM MONITOR button (or the MONITOR
SELECT button) to display the color bars on the
waveform monitor.
3. Select "DA1" from the engineering menu entry display.
* Engineering Menu *
>DA1
DA2
DA3
Others
4. Select "WFM1 Gain" and adjust the color bar signal so
that it is within the specified levels.
* DA1 *
PIX1 Gain
PIX1 DC
>WFM1 Gain
WFM1 DC
EEPROM Store
5. Select "EEPROM Store" and save the adjustment
value.
3-3. Video Signal System
PGM SIDE
INCOM
TONE RTS CANCEL
MIX
SELECT
ENTER CANCEL ENG PROD
ENG PROD
PRIVATE
MENU ON/OFF switch
AT-122 board
80
A2
80
A2
3-7 (E)