Schedule - Planet ICA-3110 User Manual

Interval
Based on the

schedule

Record File Setting
Record Time Setting
Network
Dis-connected
Network IP check
3.8.2 Schedule
For example, if you select "10 sec" here, once the motion is
detected and action is triggered, it cannot be triggered again
within 10 seconds.
When the option box is ticked, only during the selected
schedule time the motion detection is enabled. That is, for
example, the 11th hour of Monday has not been colored in the
schedule table, then no action will be triggered even the
camera detects motion during 11:00~12:00 on Monday.
IP camera allows 3 different types of recording file to change its
record size. When motion/alarm is triggered, there are 3
different types of recording modes:
(1) AVI File (With Record File Setting )
(2).Multi-JPEG (With Record File Setting), only with JPEG
compression format.
(3) Single JPEG (Single File with Interval Setting)
Pre Alarm and Post Alarm setups for video start and end time
when motion detects I/O, or other devices got triggered.
Pre/Post Alarm record time is based on record time
setting and IP cam built-in Ram memory. Limited by
IP cam built-in Ram Memory, when information is
too much or video quality set too high, it will cause
recording frame to drop or decrease on post alarm
recording time.
To avoid video loss, the camera will start to save the video
to local SD card when it detects no network connection. The
video recording will continuously be saved into SD card and
divided into every 10 minutes a file until the network is
reconnected successfully. The oldest file will be deleted if the
capacity of SD card is full.
Key in the target IP address and interval. The camera checks
once in a while according to the setting interval time if it can
link to the target IP address. If connection fails, the camera
starts to save the video to SD card
51
HD Ultra-mini Bullet IR IP Camera
ICA-3110