Table of Contents
Advertisement
3.6.3 PPPoE & DDNS
PPPoE: Stands for Point to Point Protocol over Ethernet
A standard builds on Ethernet and Point-to-Point network protocol. It allows Internet camera to
connect to Internet with xDSL or cable connection; it can dial up your ISP and get a dynamic IP
address. For more PPPoE and Internet configuration, please consult your ISP.
It can directly connect to the xDSL; however, it should be set up on a LAN environment to
program the PPPoE information first, and then connect to the xDSL modem. Power on again,
then the device will dial on to the ISP connection to the WAN through the xDSL modem.
The procedures are:
(1) Select "Enabled" to use PPPoE.
(2) Key-in username and password for the ADSL connection.
(3) Send mail after dialing：When connected to the Internet, it will send a mail to a specific
mail account. For the mail setting, please refer to "Mail and FTP" settings.
DDNS: Stands for Dynamic Domain Name Server
The device supports DDNS. If your device is connected to xDSL directly, you might need this
feature. However, if your device is behind a NAT router, you will not need to enable this feature.
Because DDNS allows the device to use an easier way to remember naming format rather
than an IP address. The name of the domain is like the name of a person, and the IP address
HD Ultra-mini Bullet IR IP Camera
41
ICA-3110
Advertisement
Table of Contents
