Schedule - Planet ICA-HM136 User Manual

Motion Detection
Record File Setting
Record Time Setting
Network Disconnected
Network IP check

5.4.2 Schedule

Schedule
Snapshot
IP CAMERA allows 3 are as motion de tection. Whe n motion is
triggered, it can send the video to some specific mail addresses,
transmit the video to remote f tp serve r, trigger the relay , and
save video to local SD card. T o set up the motion area, click
"Area Setting ". Usi ng mo use to d rag a nd draw the area. T he
same operation for area 2 and 3.
IP CAMERA allows 3 dif ferent types of recording file to chang e
its re cord size. Whe n mo tion/alarm i s trigge red, th ere a re 3
different types of record mode.
(1) AVI File (With Record File Setting )
(2).Multi-JPEG (With Re cord File Setting), only
compression format.
(3) Single JPEG (Single File with Interval Setting)
Pre Alarm an d Post Alarm setups for video st art and end time
when motion detected, I/O, or other devices got triggered.
Note: Pre/Post Alarm record time is base on record time setting
and IP Cam built-in Ram memory. Limited by IP Cam built-in
Ram Memory, When information is too much or video quality set
too high, it wi ll cause recording frame drop or d ecrease on post
alarm recording time.
When the network is down, it will sav e the video t o local SD
card.
Note: This function is only enabled in wire connection.
When the co nnection is d own, it reco rds the video to SD card.
Make sure the video re
function, key in the IP add ress of the PC which ha s recording
software inst alled. Enabl e the f unction of "Save to SD ca rd",
then click "Apply".
Note: The interval of two v ideo files on SD card is fixed with 30
seconds.
After complete the schedule se
recorded according to the schedule setup.
After enable the sn apshot function, user can sele ct the stora ge
position of snap shot file, the interval time of sna pshot and the
reserved file name of snapshot.
49
cording i s continuo us. T o use thi s
tup, the camera dat a will be
with JPEG