ProCurve 2610 Manual page 237

Table 9-1. Comprehensive Command Summary
Action Command
Configuring Standard ProCurve(config)# [no] access-list < 1-99 > < deny | permit >
(Numbered) ACLs
Configuring Extended ProCurve(config)# [no] access-list <100-199> < deny | permit >
(Numbered) ACLs
1
>
ProCurve(config)# [no] access-list < 100-199 > < deny | permit >
1
Configuring Standard ProCurve(config)# [no] ip access-list standard < name-str | 1-99 >
(Named) ACLs
ProCurve(config-std-nacl)# < deny | permit >
Configuring Extended ProCurve(config)# [no] ip access-list extended < name-str | 100-199 >
(Named) ACLs
ProCurve(config-std-nacl)# < deny | permit > ip
ProCurve(config-std-nacl)# < deny | permit > < tcp | udp >
1
Enabling or Disabling ProCurve(config)# [no] interface < port-list > access-group
an ACL
Deleting an ACL from ProCurve(config)# no ip access-list < standard < name-str | 1-99 >>
the Switch
ProCurve(config)# no ip access-list < extended < name-str | 100 -199 >>
For ACL filtering to take effect, configure an ACL and then assign it to the
inbound traffic on a statically configured port or trunk.
< any | host <src-ip-addr > | src-ip-address/mask >
2
[log]
ip < any | host <src-ip-addr > | src-ip-address/mask
2
[log]
< tcp | udp >
< any | host <src-ip-addr > | src-ip-address/mask >
[eq < src-port tcp/udp-id >]
< any | host <dest-ip-addr > | dest-ip-address/mask >
[eq < dest-port tcp/udp-id >]
2
[log]
< any | host <src-ip-addr > | src-ip-address/mask >
2
[log]
< any | host <src-ip-addr > | src-ip-address/mask >
< any | host <dest-ip-addr > | dest-ip-address/mask >
2
[log]
< any | host <src-ip-addr > | src-ip-address/mask >
[ eq < tcp/udp-port-# | well-known-port-name >]
< any | host <dest-ip-addr > | dest-ip-address/mask >
[ eq < tcp/udp-port-# | well-known-port-name >]
2
[log]
< name-str | 1-99 | 100-199 >
Access Control Lists (ACLs)
Introduction
Page
9-39
1
9-44
9-44
1
9-50
9-50
1
9-50
9-50
1
1
9-50
1
9-52
9-53
9-5