Table of Contents
Advertisement
GBC 4064WF
TROUBLE SHOOTING GUIDE
SYMPTOM
The control panel display does not
illuminate when POWER ON/OFF
is in the ON, marked "I", position
Heat rollers do not turn when
POWER ON/OFF is in the ON,
marked "I", position.
Press the RUN ( ) button and the
motor does not run
Heat rollers only turn if I use the
"Footswitch".
Laminated items exhibit curling.
Adhesive deposited on heat rollers.
Unsatisfactory adhesion of laminate.
SERVICE AGREEMENT
GBC's Equipment Maintenance Agreement will insure the quality performance and long life built into your laminator.
A service charge for travel time, labor and parts may be incurred for each out of warranty service call. GBC's Equipment Maintenance Agreement
decreases these expenses and protects your valuable investment. GBC offers several types of agreements to suit your needs and budget. To contact
GBC write to:
GBC NATIONAL SERVICE
ONE GBC PLAZA
NORTHBROOK, IL 60062 U.S.A.
General Binding Corporation
One GBC Plaza
Northbrook, IL 60062-4195
®
© 2005 General Binding Corporation
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
POSSIBLE CAUSE
Laminator not connected to electrical
supply
Blown out fuse.
Feed table not properly installed.
E-Stop button activated
Photo eye is blocked.
Tension between the top and bottom
film. Roll is unequal.
Tension on top or bottom roll of film
is too film is too loose.
Bottom film roll may be improperly
loaded.
Top and bottom film webs not
aligned
Laminate improperly loaded.
Speed setting too fast for type of
material being laminated
Insufficient heat
Laminate improperly loaded
Heat rollers require cleaning.
Laminated item unsuitable for
adhesion.
IN CANADA:
GBC NATIONAL SERVICE
49 RAILSIDE ROAD
DON MILLS, ONTARIO
M3A 1B3
Operation Manual
CORRECTIVE ACTION
Insert attachment plug into receptacle
Check fuses.
Tilt feed table and properly replace
it.
Pull out on the E-STOP turn
clockwise.
Disengage the footswitch mode.
Clear nip area.
Adjust tension per section FILM
TENSION.
Adjust tension per section FILM
TENSION.
Make sure bottom roll of film is
around idler bar and that is the
normal operation position.
Release heat and pull roller pressure,
align the rolls of film.
Adhesive (matte) side of laminate
film may be against the heat rollers.
Unweb and reload the film properly.
Lower speed setting.
Wait for "READY" indicator to
appear in the control panel display.
Adhesive side of film must be facing
away from the heat rollers.
Bottom roll of film not threaded
behind the idle bar.
Clean heat rollers per procedure in
section CARING FOR THE GBC
4064 WF LAMINATOR. Item may
be dirty or may have non porous
surface that is extremely difficult to
laminate.
Page 27
Advertisement
Table of Contents
