Sequence Of Operations - GBC 4064WF Installation & Operating Manual

GBC 4064WF

SEQUENCE OF OPERATIONS

GBC U.S &CE 4064WF
Effect of Fiber Optics on sequence of operation
Modes Situation 1
Machine Run Mode Normal operation
(No Interruption to any
safety circuitry & Fiber
optic beam)
High speed.
Control panel:
Forward Speed: Zero to
Max.
Press
button to switch over
from foot switch to the
control panel.
Foot switch:
Forward Speed: Zero to
Max.
Forward Mode
Note: Press variable
Press push button
foot pedal to change
forward switch
mode and take over
from control panel at
preset speed.
Reverse speed: Zero to
Max.
Press "Run" push
button to switch over
from Foot switch to the
Control panel.
Reverse speed: Zero to
Reverse Mode
Max.
Press Reverse
Note: Press
Push button switch.
to change mode and
take over from control
panel.
© 2005 General Binding Corporation
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
Situation 2
Interrupted fiber optic
beam or opened any
safety circuitry.
Machine stops Instantly.
Use foot pedal to override
@ 3f/m.
"Run" push
Machine Runs @
3f/m.
(Automatic override from
high to low voltage)
Machine stops Instantly.
Use Foot pedal to
override @ 3f/m.
Machine Runs @ 3f/m.
(Automatic override from
foot pedal high to low voltage)
Operation Manual
Situation 3
Fiber optic beam cleared + all safety
circuitries are closed
Machine will remain stationary until
run switch is pressed.
Push RUN button switch to run
machine again (Normal operation)
mode.
Machine still remains at low voltage
speed of 3f/m.
Steps required to run at (various
speed): The operator will have two
choices,
Choice A:
1. Release foot pedal to stop machine.
2. Press foot pedal again to start
machine at original preset control
panel knob speed (pot).
Choice B:
1. Press and hold "Run" push button
switch on the control panel while foot
is still on pedal.
2. Release foot pedal.
3. Adjust speed using "speed knob"
Machine must not run. It will remain
stationary.
Push RUN button switch to run
machine again at Normal operation
mode.
Machine still remains at low voltage
speed of 3f/m.
Steps required to run at (various
speed): The operator will have two
choices,
Choice A:
1. Release foot pedal to stop machine.
2. Press foot pedal again to start
machine at original preset control
panel knob speed (pot).
Choice B:
1. Press and hold "Run" push button
switch on the control panel while foot
is still on pedal.
2. Release foot pedal.
3. Adjust speed using "speed knob"
Page 14