Kyocera Mita FS-1000+ Installation Manual page 14

Ifs10ep-jp.book Page 12 Friday, December 22, 2000 4:27 PM
Multi-Purpose (MP) tray
Flap
Correct Correct
Correct Correct
Incorrect Incorrect Incorrect Incorrect
12
1
Pull the MP tray towards you until it
stops.
2
Pull out the subtray and unfold the flap.
Subtray
3
Adjust the position of the paper guides
on the MP tray. Standard paper sizes
are attached to the MP tray. For stan-
dard paper sizes, slide the guides to the
position marked correspondingly.
• Do not load more paper than
• If the paper is considerably
will fit under the load limits on
the inside of the MP tray.
curled in one direction, for
example, if the paper is
already printed on one side,
try to roll the paper in the
opposite direction to counter-
act the curl. Printed sheets
will then come out flat.