Installation - Ricoh B234 Service Manual

Installation

Important
• The DOS SD card must be inserted in SD card slot C2.
• If the PostScript3 option is also installed, you must move the DOS application to
the PostScript3 SD card with SP5873 001. ( 1.15.2)
1. If the machine is ON, turn OFF the
main power switch.
2. Disconnect the network cable.
3. Turn the main power switch ON.
4. Turn the operation switch and main
power switch OFF.
5. Remove the SD card slot cover [A]
( x1).
6. Hold the SD card [B] as shown and
push it into SD card slot C2.
7. Reconnect the network cable.
8. Turn the main power switch ON.
9. Do SP5878 and push [EXECUTE].
10. Exit out of SP mode.
11. Turn the operation switch OFF, then
turn the main power switch OFF.
12. Do SP5990 005 to print an SMC report.
13. On the SMC report, confirm that the two numbers listed in "ROM No./Firmware
Version" ("HDD Format Option") AND the two numbers listed in "Loading
Program" ("GW2a_zoffy") are as follows:
B7355202 Ver.1.05
IMPORTANT: The same two numbers must be listed in both sections
mentioned above.
If the numbers are not the same....
If the numbers are not identical, this means the option was not installed correctly.
• Confirm that the label on the box of the DOS option says "F".
• If you have installed the incorrect type, replace the NVRAM.
• Do the Data Overwrite Security unit installation again.
SM
Installation of MFP controller Options
[A]
[B]
1-139 B234/B235/B236/D101/D102/D103
B735I500A.WMF