Radio Shack SYSTEM 612 Owner's Manual page 11

43-461.fm Page 10 Friday, August 13, 1999 8:52 AM
2. Insert the tabs on the narrow end
of the supplied stand upward into
the lower slots near the center of
the phone, push the wide end of
the stand until it clicks into place.
3. Plug one end of one of the sup-
plied modular line cords into the
jack on the bottom of the
L1&2
phone, then
through the TELEPHONE LINE(S)
slot.
4. Plug one end of the other supplied
line cord into the
bottom of the phone, then route
the cord through
PHONE LINE(S) slot.
10
route the cord
jack on the
L3&4
the TELE-
5. Insert the supplied AC adapter's
barrel plug into the jack on the
bottom of the telephone, then
route the AC power cord through
the AC ADAPTER CORD slot. Do
not plug the adapter into the AC
outlet at this time .
Caution: The supplied AC adapt-
er supplies 12V DC, delivers at
least 300 mA, and has a plug that
properly fits the telephone's jack.
Using an adapter that does not
meet these specifications might
damage the telephone or the
adapter.