Important Notes On Product Liability; Technical Data Plast Coat 15; Tool Specification; Texture Nozzle - WAGNER PC 15 Service Manual

Important notes on product liability

As a result of an EC regulation being effective as from
January 1, 1990, the manufacturer shall only be liable
for his product if all parts come from him or are
released by him, and if the devices are properly
mounted and operated.
If the user applies outside accessories and spare
parts, the manufacturer´s liability can fully or partially
be inapplicable; in extreme cases usage of the entire
device can be prohibited by the competent authorities
(employer´s liability insurance association and factory
inspectorate division).
Only the usage of original WAGNER accessories and
spare parts guarantees that all safety regulations are
observed.

Technical data Plast Coat 15

Voltage:
Fuse protection:
Device mains cable:
Socket on the control unit
max. load:
Motor output P :
1
Max. feed rate (water):
Max. operating pressure:
Max. grain size:
Measurements L x W x H:
Receptacle capacity:
Weight:
Tire pressure, max.:
Protective system:
Max. sound pressure level:
Atomization air connection:
Max. atomization air pressure:
Required volume of
compressed air, min:

Texture nozzle:

Mortar hose:
* Measured at a distance of 1 m to the side and at a
height of 1.6 m over the device, reverberant floor.

Tool specification

Carrier sleeve take-off device
230 V ~, 50 Hz
16 A slow-blow
2
6 m long, 3 x 1.5 mm
450 watts
1.5 kW
11 l / min
40 bar
K 4 mm
1180 x 530 x 660 mm
60 l
70 kg
2.5 bar
IP 54
70 dB (A)*
Rapid action coupling
DN 7 mm
10 bar
220 l/min
8 mm (standard)
DN 27 mm,
10 m (standard)
Part No.
0348 950
3