Offset X/Offset Y - Canon imagerunner 4570 Printer Manual

I Offset X/Offset Y
-2.00 to +2.00 inch (in increments of 0.01 inch); 0.0
This setting sets the offset position in inches. The settings can be set between
-2.00" (-50.0 mm) and +2.00" (+50.0 mm) in increments of 0.01" (0.5 mm).
The print position is adjusted in the vertical or horizontal direction to the value
specified in the setting value.
You can increase or decrease the setting in increments of 0.01" (0.5 mm) to adjust
the print position, as described below.
Offset X: Increasing the setting value moves the image in the rightward X
direction on the paper. Decreasing the setting value moves the image in the
leftward X direction on the paper.
Offset Y: Increasing the setting value moves the image in the downward Y
direction on the paper. Decreasing the setting value moves the image in the
upward Y direction on the paper.
ABC DEF
Front Back
IMPORTANT
Please note that if the print position is adjusted to place print data outside the valid
print area, the portion outside the valid print area is not printed.
NOTE
•
If this setting is used in combination with the Margin setting, the values of the two
settings are added together.
•
Pressing [ ] increases the setting value by 0.01" (0.5 mm) each time the key is
pressed. Pressing [
down either [
Area adjusted using
X-Adjustment
X
Y
Adjust using
X/Y-Adjustment
] decreases the value by 0.01" (0.5 mm) each time. Holding
] or [ ] continuously speeds up the value alteration.
* inch
[+]
X
Y
ABC DEF
Front Back
Settings Menu
2
Part of the
original margin
2-15