Co Line Call Limitation - Panasonic KX-NCP500 Manual Manual

6.1.3 Flexible Buttons
Operating Manual References
1.2.1 Making Calls

3.1.17 CO Line Call Limitation

Description
CO line calls are limited by the following features:
Feature
Extension-to-CO Line Call
Duration
CO-to-CO Line Call (except
Unattended Conference Call)
Duration
Dialing Digit Restriction
during Conversation
Conditions
•
During an Unattended Conference Call, the Unattended Conference Recall time is applied. (®
3.1.18 Conference)
•
When using LCO lines that do not support Calling Party Control (CPC) signal detection (® 3.1.22 CPC
(Calling Party Control) Signal Detection), the CO-to-CO Line Call Duration timer should not be disabled,
as automatic end of call detection cannot be performed.
PC Programming Manual References
4.12 [2-7-1] Class of Service—COS Settings—CO & SMDR—
4.18 [2-9] System Options—Option 2—
5.1 [3-1-1] Trunk Group—TRG Settings—Main
→ CO-CO Duration Time (*60s)
→ Extension-CO Duration Time (*60s)
9.5 [7-5] Miscellaneous—
Document Version 2009-12
If a call between an extension user and an outside party is
established, the call duration can be restricted by the system timer
selected for each trunk group. Both parties will hear warning tones at
five-second intervals starting 15 seconds before the time limit. When
the time limit expires, the line will be disconnected. COS
programming determines whether this feature is enabled or disabled.
Whether this feature applies to outgoing calls only, or to both outgoing
and incoming calls is determined through system programming.
If a call between two outside parties is established, the call duration
can be restricted by the system timer selected for each trunk group.
Both parties will hear warning tones at five-second intervals starting
15 seconds before the time limit. When the time limit expires, the line
will be disconnected.
If both parties involved in the CO-to-CO line call were established by
an extension (e.g., an extension makes a CO line call, then transfers
the call to an outside party), the time limit applied to the CO line call
that was made first will be used.
While engaged in an incoming CO line call, the dialing of digits can
be restricted. If the number of dialed digits exceeds the limitation, the
line will be disconnected.
Extension - CO Call Limitation—For Incoming Call
Dial Digits Limitation After Answering—Dial Digits
3.1.17 CO Line Call Limitation
Description
Extension-CO Line Call Duration Limit
Feature Manual 57