Service; General; Rewiring For 240V - Shop fox W1727 Owner's Manual

General

This section covers the most common service adjust-
ments that may need to be made during the life of your
machine.
If you require additional machine service information
not included in this section, please contact Woodstock
International Technical Support at (360) 734-3482 or send
e-mail to: tech-support@shopfox.biz.

Rewiring for 240V

If you want to run your dust collector on 240V, then it
must be rewired inside the switch box and a new plug
must be installed on the machine. The rewiring job must
be inspected by a qualified electrician before the machine
is reconnected to a power source. Please read
Supply section on Page 8 before beginning this proce-
dure.
To rewire your dust collector for 240V operation, do
these steps:
1. UNPLUG THE DUST COLLECTOR!
2. Open the switch box cover by removing the screw
that secures it (as shown in Figure 17).
3. Rewire the wires inside the switch box, according to
the 240V diagram shown on the inside cover of the
switch box.
Note: Refer to the 240V Wiring Diagram on Page
20 or contact our technical support personnel if you
need additional help with this procedure.
4. After rewiring, make sure the wire nuts are tight and
are secured in place with electrical tape.
5. Install a 6-15 240V plug as specified in the Power
Supply section on Page 9.
6. Have your wiring job inspected by a qualified elec-
trician, then replace the switch box wiring cover.
Model W1727 (For Machines Mfg. Since 5/09)

SERVICE

MAKE SURE that your machine is
unplugged during all service proce-
dures! If this warning is ignored, seri-
ous personal injury may occur.
the Power
-18-
Electrical
Screw
Figure 17. Electrical box.
Box