Test Run - Shop fox W1727 Owner's Manual

Test Run

Once the assembly is complete, test run your machine to
make sure it runs properly and is ready for regular opera-
tion.
The test run consists of verifying the following: 1) The
motor powers up and runs correctly, and 2) the safety dis-
abling mechanism on the switch works correctly.
If, during the test run, you cannot easily locate the source
of an unusual noise or vibration, stop using the machine
immediately, then review Troubleshooting on Page 21.
If you still cannot remedy a problem, contact our Tech
Support at (360) 734-3482 for assistance.
To test run the machine:
1. Make sure you understand the safety instructions
at the beginning of the manual, and verify that the
machine is setup properly.
2. Make sure all the dust collection ducting and fast-
ners are tight, and that all tools and objects used
during set up are cleared away so they will not get
sucked into the dust collection intake.
3. Verify that the machine is operating correctly by
turning the machine ON.
—When operating correctly, the machine runs
smoothly with little or no vibration or rubbing
noises.
— Investigate and correct strange or unusual noises
or vibrations before operating the machine further.
Always disconnect the machine from power when
investigating or correcting potential problems.
4. Turn the machine OFF.
5. Remove the switch disabling key (Figure 15).
6. Try to start the machine with the paddle switch.
—If the machine does not start, the switch disabling
feature is working as designed.
—If the machine starts, immediately stop the
machine. The switch disabling feature is not work-
ing correctly. Call Tech Support for help.
Model W1727 (For Machines Mfg. Since 5/09)
Figure 15. Removing switch key from
-14-
paddle switch.