Base & Supports - Shop fox W1727 Owner's Manual

Model W1727 (For Machines Mfg. Since 5/09)
Base & Supports
For quiet and vibration-free operation, assemble your
dust collector as outlined below. DO NOT modify this
dust collector for any other purpose than what it is
designed for.
To assemble this dust collector, do these steps:
1. MAKE SURE THE DUST COLLECTOR MOTOR IS
UNPLUGGED!
2.
Install two swivel casters with the two
nuts and ⁄ " flat washers (see Figure 10).
5
16
3.
Install the two fixed casters with the four M6-1 x 10
cap screws (see Figure 10).
4. Place the round and rectangle support mounting
flanges against the base, and install with six
" hex bolts (see Figure 10).
x ⁄
1
2
5. With the help of an assistant, attach the impeller/
separator assembly to the supports with the remain-
ing six ⁄ "-18 x ⁄
5 1
16
6. Position the elbow as shown in Figure 11, and
secure it in place with the 10-24 x
7. Position the handle as shown in Figure 11, and
secure it in place with two
screws.
8.
Insert the ends of the bag support into the receivers
welded to the impeller/separator assembly until the
ends are completely seated (see Figure 11).
9.
Insert the bag clamps into the hemmed rim of each
dust collector bag.
10. Install the dust filter bag on the top of the dust col-
lector bag housing (the
on it), and snap the bag clamp lever closed.
11. Install the lower plastic dust collection bag, and
snap the bag clamp lever closed.
⁄
5
16
" hex bolts (see Figure 11).
2
⁄ " flange screw.
3
8
⁄ "-18 x 1" flat head
5
16
® logo is printed
SHOP FOX
"-18 acorn
⁄ "-18
5
16
Figure 10. Base assembly.
Impeller/Separator
Figure 11. Basic assembly.
-11-
Round
and
Rectangle
Support
Mounting
Flanges
Fixed
Caster
Bag
Support
Handle
Receiver
Assembly
Elbow
Swivel
Caster