Other Problems - JVC HR-DVS3EK Instructions Manual

86

OTHER PROBLEMS

SYMPTOM
1. Whistling or howling is heard from the
TV during camcorder recording.
2. When scanning channels, some of
them are skipped over.
3. The channel cannot be changed.
4. Channel settings that were made
manually seem to have changed or
disappeared.
5. No channels are stored in the
recorder's memory.
6. The remote control won't operate the
TV or satellite receiver.
7. No picture appears when you connect
a device to DV IN/OUT connector.
ATTENTION
This recorder contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases, switch
the recorder off and unplug the mains power cord. Then plug it in again and turn the recorder on. Take out the cassette. After
checking the cassette, operate the unit as usual.
POSSIBLE CAUSE
The camcorder's microphone is too
close to the TV.
The TV's volume is too high.
Those channels have been designated to
be skipped.
Recording is in progress.
After the manual settings were made,
Auto Channel Set was performed.
The TV aerial cable was not connected
to the recorder when Auto Set Up was
performed.
The fully-wired 21-pin SCART cable was
not connected between TV and the
recorder when Preset Download was
performed.
The remote control brand setting is
incorrect.
TROUBLESHOOTING (cont.)
CORRECTIVE ACTION
Position the camcorder so its microphone
is away from the TV.
Turn the TV's volume down.
If you need the skipped channels, restore
them ( pg. 74).
Press to pause the recording, change
9
channels, then press to resume
4
recording.
Perform manual setting again.
Turn off the recorder once and connect
the TV aerial cable to the recorder
properly, then turn on the recorder again.
The recorder will try Auto Set Up again
( pg. 13).
Turn off the recorder once and connect
the fully-wired 21-pin SCART cable to the
recorder properly, then turn on the
recorder again. Then perform Preset
Download again ( pg. 14).
Re-set the remote control to the correct
brand. ( pg. 61, 62)
Turn off the recorder or the connected
appliance once, then turn it on again.