DURKOPP ADLER 906 Operating Instructions Manual page 103

Settings via the software
Overview of the individual machine parameters
Operating instructions 906 - Version 00.0 - 05/2014
MP1 - Configuration
Symbol Meaning
Needle cooling
The following options can be set:
None: No type of needle cooling is active.
Air cooling (Def.): The needle is cooled with air while sewing the seam.
Ice cooling: Optional equipment.
Foot mode
The foot can be operated in the following modes:
Hopper (standard mode): The foot only presses on the sewing material
while the needle is in the sewing material.
Presser: The foot presses continuously on the sewing material.
Sewing field size
No function.
Optional equipment
Reduced clamp pressure:
Optional equipment allowing only a small amount of clamp pressure to
allow better alignment on insertion.
Laser marking lights:
Optional equipment providing orientation lines on insertion for easier align-
ment. Up to 4 laser marking lights can be switched on for each program.
This setting only activates the option, the actual switching is defined in the
program parameters (
Barcode reader:
Optional equipment for performing a safety check before sewing. A barcode
can be stored with each program. Agreement with the barcode on the
clamp is checked. Sewing only proceeds when the barcodes agree.
You enter the barcode ID in the program parameters (
page 94).
Clamp type
No function.
Clamp limits
Standard limits (Def.)
No additional structures are taken into account.
Special limits
Individual limits are taken into account.
Foot pedal
Raising and lowering the transfer plate.
Hand sensor (two-hand control)
By simultaneously using both hand sensors, the sewing process is started.

Laser marking lights, page 94).

Clamp ID code,
101