Table of Contents
Advertisement
REMOTE (2/2) Menu screen (continued)
REMOTE menu
Items
PB START
0F
DELAY
15F
SYNCHRONI-
OFF
ZATION
ON
TYPE1
CONTROLLER
SEL
TYPE2
TYPE3
TYPE4
TYPE5
TYPE6
TYPE7
FOOT SW
OFF
L EDGE
H EDGE
L LEVEL
PAGE BACK
Setting
For adjusting the edit timing. With the remote controller in use, if
|
the start points of edit are not concurrent, adjust the playback
startup timing:
0F
1F to 15F
For enabling/disabling the bump function when BR-DV6000 is
connected to an editing remote controller:
OFF
ON
For setting the type of controller to be connected when remote
control is enabled with the RS-422A interface:
TYPE1
TYPE2
TYPE3
TYPE4
TYPE5 - TYPE7 : (Not in use)
For setting when an external switch (e.g., a footswitch) is con-
nected to the SERIAL REMOTE terminal. Before operating an
external switch (footswitch) with L EDGE or H EDGE, turn BR-
DV6000 to the RECORDING PAUSE or RECORDING mode:
OFF
L EDGE
H EDGE
L LEVEL
Return to the REMOTE (1/2) Menu screen.
Description
: No correction.
: Delays the timing by the number of frames set by
the user. When BR-DV6000 is connected to an
editing remote controller with no bump function,
use this setting to adjust the editing precision.
: No synchronization.
: Performs synchronization. The editing precision
is enhanced. Please set the pre-roll time to at least
7 seconds.
: RM-G820
: RM-G860 (set the preroll time to at least 10
seconds)
: AG-A850
: RM-450,PVE-500
: For when the external switch is not used.
: Recording and recording pause is switched at the
LOW edge of the external switch signal.
: Recording and recording pause is switched at the
HIGH edge of the external switch signal.
: Record at the LOW edge and pause recording at
the HIGH edge of the external switch signal.
E-77
Advertisement
Table of Contents
