Table of Contents
Advertisement
REMOTE Menu screens
The REMOTE Menu consists of the following two screens (1/2 and 2/2).
REMOTE (1/2) Menu screen
Item
REMOTE SEL
9P
Memo
When the RS-232C board SA-K46U (sold separately) is installed, the name of this item changes
to REMOTE SEL 232.
Use this setting to enable/disable the control via RS-232C when the REMOTE/LOCAL switch
on the front panel is set to REMOTE.
REMOTE SEL
SER
REMOTE SEL
DV
REMOTE SEL
JVC
REMOTE SEL
NET
Setting
OFF
For enabling/disabling the REMOTE1 (9-PIN) terminal when the
ON
REMOTE/LOCAL switch on the front panel is set to REMOTE.
OFF
ON
OFF
For enabling/disabling control via the SERIAL REMOTE IN ter-
ON
minal.
LOC+REM
OFF
ON
LOC+REM
OFF
For enabling/disabling control via the DV terminal.
ON
OFF
LOC+REM
ON
LOC+REM
OFF
For enabling/disabling the REMOTE 2 (12-PIN) terminal when
the REMOTE/LOCAL switch on the front panel is set to REMOTE.
ON
OFF
ON
For enabling/disabling control via the network board SA-DV6000
OFF
(sold separately).
ON
LOC+REM
OFF
ON
LOC+REM
Description
: Control through RS-422A disabled
: Control through RS-422A enabled
: Control disabled regardless of the settings of the
REMOTE/LOCAL switch
: Control enabled only when the REMOTE/
LOCALswitch is set to REMOTE.
: Control enabled regardless of the settings of the
REMOTE/LOCAL switch.
: Control disabled regardless of the settings of the
REMOTE/LOCAL switch.
: Control enabled only when the REMOTE/
LOCALswitch is set to REMOTE.
: Control enabled regardless of the settings of the
REMOTE/LOCAL switch.
: Control through the JVC bus disabled
: Control through the JVC bus enabled
: Control disabled regardless of the settings of the
REMOTE/LOCAL switch.
: Control enabled only when the REMOTE/
LOCALswitch is set to REMOTE.
: Control enabled regardless of the settings of the
REMOTE/LOCAL switch.
E-75
Advertisement
Table of Contents
