Installing And Removing Xfp Modules - Cisco ASR 9000 Series Installation Manual

Chapter 2 Installing Line Cards in the Cisco ASR 9000 Series Router

Installing and Removing XFP Modules

The 10-Gigabit Ethernet(GE) XFP transceiver module is a hot-swappable I/O device that plugs into
10GE ports
with the optical network.
Figure 2-23
1
2
3
The dual LC connector on the XFP transceiver modules supports network interface cables with either
Note
Physical Contact (PC) or Ultra-Physical Contact (UPC) polished face types. The dual LC connector on
the XFP transceiver modules does not support network interface cables with an Angle Polished
Connector (APC) polished face type.
(Figure 2-23). The XFP transceiver module connects the electrical circuitry of the system
10-Gigabit Ethernet XFP Transceiver Module
4
5
1
2
6
Transmit optical bore
Receive optical bore
Transceiver socket connector
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
Installing and Removing XFP Modules
3
4 Bale clasp (locked position)
5
Dust plug
6
Bale clasp (unlocked position)
2-39