Table of Contents
Advertisement
Available languages
Available languages
English
NAILER OPERATION
Read section titled "SAFETY" (pages 4-9)
charge area when using. The tool may bounce from the recoil
of driving a fastener and an unwanted second fastener may be
•
driven possibly causing injury.
Do not drive nails on top of other nails or with Nailer at too
•
steep of an angle; nails can ricochet and hurt someone.
Do not drive nails into thin boards or near corners and edges of
workpiece. Nails can be driven through or away from work-
•
piece and hit someone.
•
Never use Nailer which is defective or operating abnormally.
•
Do not use Nailer as a hammer.
Disconnect air hose from Nailer when:
1) It is not in use;
2) Leaving work area;
3) Moving it to another location; and
•
4) Handing it to another person.
Wear safety glasses and safety shoes for protection against
•
foreign objects.
•
Never use a Hammer with a loose head or splintered handle.
•
Use only nails from Hitachi.
Air supply hoses should have a minimum working pressure rat-
ing of 150 PSI or 150 percent of the maximum pressure pro-
•
duced in the power source, whichever is higher.
Check all hoses before connecting to ensure that they are free
from dirt, grit, or particles that could alter the performance of
the tool.
DANGER
•
Operators and others in work area
MUST wear safety glasses with side
shields which conforms to ANSI Z87.1
specifications.
WARNING
•
NEVER point tool at yourself or oth-
ers in work area.
•
Keep fingers AWAY from trigger when
not driving nails to avoid accidental
•
operation.
Never place your face, hands or feet
closer than 8 inches (200 mm) from dis-
— 20 —
Advertisement
Table of Contents
