Citizen CBM1000 TYPE II Service Manual page 15

(5) Installing Brake and Stepping Motor
• Attach brake on main chassis with a screw
(M3 × 6 (ST)) while making sure that it is
oriented properly.
• Attach stepping motor on main chassis with
two screws (M3 × 6 (ST)), with its cables
dangled down.
(6) Installing Pressure Arms
• Attach pressure arm-R on bar ring (at
pivoting center) on the right side of main
chassis, and then install EXT spring-01 as
shown.
• Attach pressure arm-L on one of the stepping
motor retention screw head on the left side of
main chassis, and then attach EXT spring-01
as shown.
Main chassis
M3 × 6 (ST)
Main chassis
Pressure arm-L
11
CBM1000 TYPE II Service Manual
M3 × 6 (ST)
Brake
Stepping motor
Pressure arm-R
EXT spring-01